原装霍尼韦尔执行器M7284Q1082湖北供应商

原装霍尼韦尔执行器M7284Q1082湖北供应商
产品资料：
1. When wiring, use only recommended crimp terminals.
2. Do not block areas around the product for proper dissipation of 
heat. (If you do not secure space for heat dissipation, life cycle of 
the product will be compromised.)
3. To avoid electrical shocks, make sure that power is not supplied to 
the product while wiring.
4. To avoid electrical shocks, make sure that power is not supplied to 
the product when performing DIP switch settings.
Noise Countermeasures
1. Do not install the product near devices generating strong high 
frequency waves or surges.
2. When using a noise filter, check the voltage and current and 
install it as close to the product as possible.
3. In order to prevent inductive noise, wire the lines connected to the 
product separately from power lines carrying high voltages or 
currents. Do not wire in parallel with or on the same cable as 
power lines. 
Other measures for reducing noise include running lines along 
separate ducts and using shield lines.
To avoid faulty operations, 
malfunctions, or failure, observe the 
following operating instructions.
1. When turning on the power, make sure to realize rated voltage 
within 1 second from the time of first supply of electricity.
2. Make sure to use power supply for operations, inputs, and 
transformer with the appropriate capacity and rated burden.
3. Maintenance and handling of this product may only be performed 
by qualified personnel.
4. Distortion ratio of input wave forms must be 30% or less. Use of 
this product with circuits that have large distortion in wave forms 
may result in unwanted operations.
5. Using this product for thyristor controls or inverters will result in 
errors.
6. When setting the volume, adjust the control from the minimum 
side to the maximum side.
Checking Operation
Overvoltages
Gradually increase the input from 80% of the setting.
The input value will equal the operating value when the 
input exceeds the setting and the alarm indicator starts 
flashing. Operation can be checked by the relay output that 
will start after the operating time has passed.
Undervoltage
Gradually decrease the input from 120% of the setting and